Ask The Builder

Tile backsplash a smart, attractive idea in bathroom

September 30, 2007|By Tim Carter | Tim Carter,Tribune Media Services

I think a tile backsplash would be a great way to make my bathroom look better. Do you have to buy special backsplash tile? I'm open to any backsplash tile ideas, including a glass tile backsplash. If you were installing a ceramic tile backsplash, how would you do it, and what pitfalls would you avoid? Do I need any specific tools or skills to complete this job?

Tile backsplashes in bathrooms or kitchens are a great idea. I like them for all sorts of reasons. First, they are almost entirely waterproof. And because tiles come in all sorts of textures, colors and patterns, a tile backsplash can become a focal point. This is especially true when the countertop is natural stone, such as granite or marble, or a manmade stone composite.

Special tile is not required for this job, but you may want to consider it. Regular flat tile that is common in many bathrooms will work, but you have to make sure you purchase a tile with a finished edge, or one that comes with trim tile.

Because ceramic tile is often 1/4 -inch thick - and sometimes thicker - the transition from tile to the wall surface must be made with trim tiles that have a finished edge on at least one side. These tiles are frequently referred to as bullnose tiles. They have a soft rounded edge that is the same color as the tile.

For a drop-dead gorgeous look, visit a specialty tile store that sells only tile and tile products. There you will probably discover cornice tiles that resemble woodwork trim. The profile of the tile is nearly identical to woodwork, where one edge of the tile is thicker. These tiles are often rectangles and sometimes come with profiled outside corners in case you have an outside corner as part of your backsplash.

Before you choose the tile for your backsplash, slow down and think about the look you want to have for years. Ceramic tile, in my opinion, is not a short-term decorating product. Tile is often expensive and requires a significant amount of work to install. If you purchase a high-quality tile, it can last for 50 or even 100 years. For this reason, you will want to pick a ceramic tile that will age gracefully. Some modern tile styles are transitional in my opinion. They may be dated in as few as 10 or 20 years.

There are all sorts of different installation tips, depending upon what type of tile you select and the type of countertop it rests on. Recently I installed a stunning decorative tile backsplash on a granite top. Before I started, I caulked the joint where the granite met the wall. After the caulk was dry, I then sealed the granite well, especially the small area where the tile would overlap the granite.

You want a small 1/16-inch space between the bottom of the tile and the countertop. This gap should be caulked with a caulk that matches the color of the grout. You can frequently find these specialty caulks at stores that sell only ceramic tile. Some caulks are made to exactly match specific tile grout colors.

I prefer to grout the backsplash tile first. If any grout gets into the gap between the tile and countertop, remove it immediately with a toothpick. If you wait until the grout hardens, removing it is risky. One slip with the tool and you could scratch the tile or the countertop.

Most tile backsplashes can be installed with a minimum of tools. Regular tile can be scored and cut with a tile snapper. Fancy tiles must be cut with a wet diamond-blade saw. Miter joints for inside corners are best cut with this same saw. These saws can be rented if a friend doesn't own one you can borrow.

As for skill, installing tile requires attention to detail and precise measuring ability. Tile grout joints for backsplashes vary from 1/16 inch up to and including 1/4 inch. When a cut tile is too short, the resulting fatter grout line is more visible than a lighthouse beacon on a clear night. Take your time measuring, marking and cutting the tiles.

Expert home builder and remodeling contractor Tim Carter has 20 years of hands-on experience in the home industry. He is a licensed master plumber, master carpenter, master roof cutter and real estate broker. If you have a question, go to askthebuilder.com and click on "Ask Tim."

Baltimore Sun Articles
|
|
|
Please note the green-lined linked article text has been applied commercially without any involvement from our newsroom editors, reporters or any other editorial staff.